corrugated cardboard production online case in Asia
Whatapp (weichat): +86-13801968812
|LXC-1500H Hydraulic Mill Roll Stand
Control type: whole hydraulic type Characteristic
* Symmetry structure could install two bundles real paper at the same time, and change the paper without any stop.
* Adopt hydraulic drive that could make the real paper lift-lower, clamp and release and move.
* Adopt pneumatic strain to adjust the real paper.
* Expanding clips design.
* Tension control by pneumatic brake system, manual controlled and also can be controlled by splicer.
The maximum paper width: 2500MM.
* Pass the national pressure vessel inspection, and get a safe certification about national pressure vessel security;
* One is fixed, another one free to move, both of them are steel products.
* Warm-range adjustment adopts electric control.
* Power motor 1/2HP gear with a turbine and a drive arm with gear transmission.
* The preheated rollers are electrically rotating, with reducing motor and single ball bearing can set idle running with stable speed.
|“LXC-320S Single Facer
Available working width: 1400-2200mm.
Paper delivering by suction blower, to keed good flute under high speed working;
|LXC-1B/2B Single/Double Decks Feeding Bridge
Available width: 1400 – 2500 mm
* Adopt suction tension and its adjusting device, assure the sticking and stable paperboard pass by of the heating plate
* Motorized alignment adjustment, easy and swift
* Two set of operation panels, make easy adjustment up or down the bridge
* Synchronous motor driving, with high and low speed stacking device, to transport and stack the corrugated paperboard.
|“LXC-288D Glue Machine(Spring Press Board is for option)
|“LXC-636E Steam-heating & Press-cooling System
LXC-636E-D Driving RollerSpecification:
Voltage: 380V 50Hz
|“LXC-150P Slitter Scorer With Thin Blade
|“LXC-150/180 Double Layer NC Cutoff with Rotary Blade